The method, plainly
Lacquer work here is subtractive. Everything that will ever be seen is buried first, and the picture arrives when the surface is cut away to meet it.
The board we start on
A board is planed flat, sized so it will stop drinking, and covered with a thin cloth across every joint. Then the black ground goes on. If the ground moves later, nothing above it is worth having, so this coat gets more time than any other.
Only when the ground is hard enough to ring under a fingernail does the first colour go near it.
A seven-coat board
This is the stack the depth dial on the front page is drawn from. Clear black on top is the thickest coat, since every cut eats it first.
From board to face
1
Lacquer goes hard by pulling damp from the air around it, so the drying room is cool and wet. A heater does the opposite of what everybody expects.
2
A coat that is still soft underneath will not hold the one above. We load the room, close it and leave it.
3
Wet paper and a flat block take the face down evenly. Wherever the stack stood proud, a lower colour breaks through as an island.
4
The last pass is the heel of the hand with a little oil. Buffed and burnished faces catch light in different ways, and the hand wins.
Eggshell and leaf
Shell is laid into a coat that has not set, then pressed until it crackles. That crack is the whole reason to use it: a flat white would read as paint, and a broken one reads as light.
Leaf goes down the same way, and gets buried like everything else. You will not see it until something cuts down to it.
A coat rushed stays soft under the next one. You will not know for a year, and then the whole stack lifts off in a sheet.
Đỗ Văn Thuận, who loads the damp room
The water bench at the water bench is the quickest way to understand any of this.