Hạ Thái · lacquer at the board

Seven coats go on. One cut decides what you see.

We sell days at the bench, not panels. You lay colour that nobody will see for months, or you cut back a board we prepared last season and find the picture that was already in it.

Raw lacquer can blister skin. Every board a visitor touches was coated and cured by us long before the day.

  • Clear black150 microns
  • Ochre55 microns
  • Eggshell65 microns
  • Gold25 microns
  • Black55 microns
  • Cinnabar60 microns
  • Ground black130 microns
Broken eggshells laid out on a white trayBroken eggshells laid out ready for the next soft coat.

Three states of one board

Painted boards lapped over one another in bands of colour

Grounded

A flat board is sized, cloth is laid over the joints, and a black ground goes on and cures hard before anything coloured is allowed near it.

Dark rock split along the lines of its own layers

Layered

Colour after colour, each one cured in damp air before the next. A coat rushed stays soft under the one above it and the whole stack lifts later.

Black and white colour swirled together on a glossy surface

Sanded

Wet paper takes the face down. Wherever the cut goes deep the buried colour surfaces as an island, so the pattern is found rather than painted.

Pick a depth

What the cut opens

The stack on the left is a real seven-coat board, 540 microns of lacquer over the wood. Move the cut down and watch which coats reach the surface.

Board and stack, in sectionThe face the cut leaves

Just flat

Microns off
30
Coats showing
1 of seven
Coats laid bare
the clear black only

Nothing is cut. The face is the last coat we brushed, and the colour underneath is a rumour.

Laying a coat flat and even, then carrying the board to the damp room for the next pair of hands.

The First-Coat Morning · The Full Layering Day

Through the black

Microns off
165
Coats showing
2 of seven
Coats laid bare
the clear black and the ochre

The high spots open first. Ochre arrives as scattered patches while the black still holds the low ground.

Working wet paper in slow circles until the first buried colour breaks the surface.

The Sanding-Back Afternoon · The Families' Short Sitting

Into the eggshell

Microns off
240
Coats showing
3 of seven
Coats laid bare
the ochre, the eggshell and the gold

The white comes up broken, because the shell was pressed into a soft coat and crackled as it went.

Easing off a little at a time. One pass too far takes the white away and it cannot be put back.

The Near-Look Morning · The Pigment and Gold Morning

Down to the red

Microns off
330
Coats showing
4 of seven
Coats laid bare
the eggshell, the gold, the black and the cinnabar

Four coats open at once. The red reads as islands because the stack above it was never flat.

Cutting deep on a board that can take it, then burnishing the face by hand rather than buffing it.

The Two-Day Panel Course · The Two-Seat Day

No board is finished in a day, and nobody here will guess a date for you. A coat goes hard when it goes hard; the damp room decides that, never the calendar.

Three boards to start

Eight boards in all

Who takes the bench

People arrive wanting to paint something. By eleven they have stopped painting and started looking, because the board already holds more than they could put in it.

Phạm Thị Nhàn, who runs the water bench

Nhàn and Đỗ Văn Thuận keep eight boards in rotation at any time. Thuận grinds the pigment and loads the damp room; Nhàn decides when a board is hard enough to hand over.

Finding the open shed

Ngõ Sơn leaves the village road just past two pottery yards. Ours is the open shed with boards stacked on edge; the closed one behind it is the damp room, and that door stays shut.

Hold me a board
Where
Ngõ Sơn, Hạ Thái, Thường Tín
Open
Tuesday to Sunday, 8.00 to 17.30
Shut
Monday, while the damp room is loaded